 Console Repair / Inner Wheel House, latest updates |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| thomasotten |
 Nov 29 2003, 08:26 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,545 Joined: 16-November 03 From: San Antonio, Texas Member No.: 1,349  |
This is prior to welding. It took several vises and clamps at various places and often repositioning to get this in right. In fact, I had to trim off about 1/8" from the lower most bottom piece that buts to the longitudinal seem or else it would have never fit right. It took a bit of hammering too.
Attached image(s) 
|
   |
 
|
Posts in this topic
thomasotten Console Repair / Inner Wheel House Nov 29 2003, 08:26 AM
thomasotten After doing a couple of crappy welds, I remembered... Nov 29 2003, 08:34 AM thomasotten After feeling pretty good about some of the welds ... Nov 29 2003, 08:37 AM thomasotten Then, I took a screwdriver and hammered around the... Nov 29 2003, 08:44 AM DNHunt Man that's looking good. It feels really good ... Nov 29 2003, 06:16 PM Bleyseng Turn the heat up alittle so you get more penetrati... Nov 29 2003, 06:42 PM
TimT When welding upside down, reversing the polarity c... Nov 29 2003, 06:48 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th May 2024 - 08:11 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.