 Pre-induction system install question, 3-prong electrical fitting? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| mstein95 |
 May 6 2007, 04:37 PM
Post
#1
|
|
Back when grey Levi's were the rage.  Group: Members Posts: 404 Joined: 1-May 06 From: Eugene, OR Member No.: 5,959 Region Association: Pacific Northwest  |
Keep in mind - newby rebuild.
Just about to install stock D-Jet fuel injection system onto fresh rebuild when I read a sentence out of Tom Wilson's How to Rebuild Your Volkswagen Air-cooled Engine: "on fuel-injection engines, there is an electrical-ground fitting that mounts under the head of one of the case bolts. This fitting has three spades for electrical connectors. If you install the intake manifold without this piee in place, it's nearly impossible to install it with the injection in place." I pause, swear, and wonder what the bleep Tom is refering to. (IMG:style_emoticons/default/WTF.gif) I've looked through the Haynes manual and don't see any reference to this fitting. My questions: 1) Do I need this fitting for the D-jet set up? 2) Does anyone have a picture of this fitting? Installed? 3) Where might I source this fitting? Thanks |
   |
 
|
Posts in this topic
mstein95 Pre-induction system install question May 6 2007, 04:37 PM
Cap'n Krusty It's a washer with 3 male push-on connector ta... May 6 2007, 05:31 PM
mstein95 Thanks Cap'n. I going to check my local sour... May 6 2007, 10:27 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 25th May 2024 - 01:23 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.