 Lets Talk About Lapping Cylinders, Have I got this right? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| DuckRyder |
  Dec 23 2003, 10:08 AM
Post
#1
|
|
Avatars Mode: OFF because of the recalcitrant few.  Group: Benefactors Posts: 767 Joined: 8-January 03 From: Georgia Member No.: 110   |
So, we leave out the "head gaskets" and lap the cylinders into the head?
1) I assume we are using valve-grinding compound. 2) I am going to insert each cylinder into the head where I am going to install it. 3) I spin said cylinder until I see a nice shiny ring on the head and rim of the cylinder. Have I got that right? |
   |
 
|
Posts in this topic
DuckRyder Lets Talk About Lapping Cylinders Dec 23 2003, 10:08 AM
Brad Roberts I dont know how shiny it will be... but you have e... Dec 23 2003, 10:36 AM thesey914 Maybe not just spin...but in a back and forward mo... Dec 23 2003, 10:39 AM Tom Perso The ring should be a dark color, full coverage aro... Dec 23 2003, 10:40 AM DuckRyder O.K. Spent the day putting the bottom end together... Dec 23 2003, 04:13 PM Jake Raby Use a piece of thick glass with 400 grit sandpaper... Dec 23 2003, 05:34 PM
kdfoust Duck: when lapping use a figure-8 motion. Dec 23 2003, 06:33 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th May 2024 - 10:25 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.