 Fixing the rocker covers, Saving them from cancer |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| DNHunt |
 Dec 14 2007, 10:09 PM
Post
#1
|
|
914 Wizard? No way. I got too much to learn.  Group: Members Posts: 4,099 Joined: 21-April 03 From: Gig Harbor, WA Member No.: 598  |
Here's what I started with. Rust in the area under the opening for the jack plate.
 Because there are some compound curves I decided to fill a small amount with welding and cut the rusty metal from the flatter area.  |
   |
 
|
Posts in this topic
DNHunt Fixing the rocker covers Dec 14 2007, 10:09 PM
DNHunt I cut out the bad metal.
Then I bent and hamm... Dec 14 2007, 10:13 PM McMark :drooley:
Nice Dave!!! :thumbsup: Dec 14 2007, 11:17 PM DNHunt Finished 1 side, at least it's ready for prime... Dec 15 2007, 09:12 AM Gint You're getting pretty good at that Dave. Dec 15 2007, 09:34 AM DNHunt Here's how I did it. I used a vice, a piece of... Dec 15 2007, 11:10 AM DNHunt Then I measured from the center of that bend on th... Dec 15 2007, 11:15 AM DNHunt I cut the patch to length and added the mounting h... Dec 15 2007, 11:22 AM DNHunt This is what you end up with to be welded in.
D... Dec 15 2007, 11:24 AM rhodyguy nice work dave. Dec 16 2007, 11:06 AM
DNHunt Homemade paint booth in an unused greenhouse
Pl... Dec 16 2007, 09:43 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 18th May 2024 - 07:53 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.