 Pre-shop Checklist, ...goin to the welder |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| stateofidleness |
 Jun 1 2008, 08:00 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 810 Joined: 1-September 07 From: Canyon Lake, Texas! Member No.: 8,065 Region Association: None  |
Hey guys, new at this stuff and just wanted to know what I should have done before
I trailer the car to the welder for floorpan and hell hole work. I have the interior stripped minus the dash and windshield and wiring harness. Engine is out. What do I do with the throttle/clutch cable and how bout the rear CV's? Also, what is the best place to tie down the car to the trailer.. and maybe some tips that a noob might not know when it comes to trailering one of these? thanks so much! im excited!! it goes into the shop tomorrow *hopefully* |
   |
 
|
Posts in this topic
stateofidleness Pre-shop Checklist Jun 1 2008, 08:00 AM
stateofidleness bump for noob Jun 1 2008, 10:40 AM SGB I find putting plastic grocery bags over the CVs, ... Jun 1 2008, 11:57 AM stateofidleness should i even take the top? chance it might get da... Jun 1 2008, 12:03 PM Gint bump for noobYou're kinda past that stage by n... Jun 1 2008, 03:03 PM stateofidleness ha! have i progressed past the noob stage? thi... Jun 1 2008, 03:35 PM
Phoenix 914-6GT If you have the wiring harness out you may as well... Jun 1 2008, 07:16 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th May 2024 - 11:56 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.