 mangled push-rod tubes, is there a better way? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| bryanf |
 Apr 27 2009, 01:50 PM
Post
#1
|
|
Member  Group: Members Posts: 105 Joined: 18-January 06 From: Half Moon Bay, CA Member No.: 5,435  |
I'm finally getting around to replacing the pushrod tube seals and I'm following the AA procedure using AA viton seals. Unfortunately when I try to seat the new seals by grabbing them with pliers and seating them, I need to grab the pushrod tubes with so much force that I'm denting and mutilating them in the process. It there a better way? Should I but hose clamps around them first?? Ideas?
The engine is in the car by the way... TIA Bryan |
   |
 
|
| underthetire |
Apr 27 2009, 02:01 PM
Post
#2
|
|
914 Guru Group: Members Posts: 5,062 Joined: 7-October 08 From: Brentwood Member No.: 9,623 Region Association: Northern California |
KY Not just for her pleasure.
|
|
|
|
| SLITS |
Apr 27 2009, 02:10 PM
Post
#3
|
|
"This Utah shit is HARSH!" Group: Benefactors Posts: 13,602 Joined: 22-February 04 From: SoCal Mountains ... Member No.: 1,696 Region Association: None  |
Never had a problem seating them. I grab them with channel locks and hit the pliers in the handle area with the heel of my hand
, but .... Use a socket with a diameter that matches the od of the tube flange and "pop" it with a light blow from a hammer. |
|
|
|
| turboturtle |
Apr 27 2009, 02:12 PM
Post
#4
|
|
Member Group: Members Posts: 56 Joined: 19-February 09 From: Little Rock, Arkansas Member No.: 10,068 Region Association: None |
Scented n flavored not necessary unless......
A couple of mine look rough, but unless their collapsed, a little denting will not hurt. Your not expecting any visitors there, are you. If so you could spin them around to show the best side down. |
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th May 2024 - 12:18 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.