 To Shim or Not to Shim...that is the question, throw out pivot ball |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Porsche Rescue |
 Aug 4 2009, 12:17 PM
Post
#1
|
|
Saving and Enjoying Old Porsches  Group: Members Posts: 2,978 Joined: 31-December 02 From: Bend, Oregon Member No.: 64 Region Association: None  |
Just had my flywheel resurfaced. Only removed .011. I think it is the first time it has been turned. I can't find a shim washer in my stock less than .020. Do I even need to bother? And if so should I go thick at .020 or try to find a thinner washer?
|
   |
 
|
Posts in this topic
Porsche Rescue To Shim or Not to Shim...that is the question Aug 4 2009, 12:17 PM
orange914
Just had my flywheel resurfaced. Only removed .0... Aug 4 2009, 03:24 PM Porsche Rescue .011 was removed from both flywheel surfaces. I am... Aug 4 2009, 03:40 PM Cap'n Krusty While you could probably get by without a shim, I... Aug 4 2009, 04:49 PM Porsche Rescue Thank you Cap'n. It will be done. Aug 4 2009, 05:13 PM Porsche Rescue Oops. My ignorance is exposed. Is there a washer u... Aug 4 2009, 05:26 PM r_towle sounds like a plan.
Is the clutch fork straight? t... Aug 4 2009, 05:30 PM
Porsche Rescue Thanks Rich. Aug 4 2009, 05:35 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 21st May 2024 - 10:03 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.