I have an LX91 (model # fixed, thanks mcmark) ignition coil. The plug wires in my car need to be replaced, so I bought the stock bosch set from PP.

The connector on the coil --> dizzy wire doesn't fit over the contact nub in on the LX91.

Does anyone know what wires will fit properly? Should I get a set of magenores?

Looks something like this:

McMark, that's the correct part, I fat fingered the model #!

Yup, stock center lead won't work. Stock wires are meant to slide into a tube. You need the style that go around the pin.

You can get the supplies to make your own at most FLAPS. I got mine at NAPA. I can make a cable for you if you can't find anything else.

Can't tell you off the top of my head what would work though. Too many combinations out there.