On the two from the 914/6 oil tank and the oil line coming off the block? My mind is fading in my old age....BTW....I will be cutting the one coming off the engine cooler and soldering on a 90 to clear the swing arm...
Are they (2) 30mm and (1) 26mm with a 1.5 pitch?
I am looking at BAT in Florida that carries the XRP conversion fittings.....to -12AN.....looks like HPH is having a hard time getting them from their supplier....
Also....do any of them need a 45 or 90 bend? Been ahwile since I had to plumb one of these....
Also...anyone have an oil console, cap, dipstick and filler neck? Early 911 stuff works....so if ya have an old crappy tank laying around.....