I was wondering if the part where the left tornsion bar front, is mounted exists as a repair panel
http://www.914world.com/bbs2/index.php?s=&...t&p=1039858

Can i use a 911 repir part if one exists? Now that we have delved into this, it looks a bit worse then i expected?

Any ideas?


Roman

It may be available. If not, you can get one off a donor car. This may be the best way to go. There should be plenty around.

you will need a front trunk floor pan also.

I suggest you send that pic to restoration design to see if they can help you out.

Rich

ta, I will do that lots of donor cars in the UK, err no....

While that maybe true in the UK, there are plenty here in the USA. I would contact restoration design like Rich said and / or post extactly the size of the section you need plus a little extra so it can be trimed to fit.

There is a guy on the Samba in FS section that is going to cut up and scrap a 914
see this LINK

Place a WTB add here, the club, and pelican.

Good luck. I give you credit for saving another 914

Recent post for cutting up a car - http://www.914world.com/bbs2/index.php?sho...=131329&hl=