Is there a difference between Mahle and Kolbenschmidt rod bearings?
Is one preferred over the other?
Full Version: rod bearings manufacturer preference
Not really, plus they may be made in the same factory.
Silverlines suck.
Silverlines suck.
QUOTE(Mark Henry @ Mar 7 2013, 05:36 PM) 
Not really, plus they may be made in the same factory.
Silverlines suck.
Silver lines are a brand?
QUOTE(jmargush @ Mar 7 2013, 07:56 PM)
QUOTE(Mark Henry @ Mar 7 2013, 05:36 PM)
Not really, plus they may be made in the same factory.
Silverlines suck.
Silver lines are a brand?
These days most are equally worthless.. We try to work from old stock, go to thesamba or ebay and see if you can find some NOS bearings.
We just pulled a Chinese cylinder out of a brand new set of Mahle P&Cs that were unopened today. Quality is gone across the board.
We just pulled a Chinese cylinder out of a brand new set of Mahle P&Cs that were unopened today. Quality is gone across the board.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.