i did see a post where upon removal of carbs a red wire was used fro fi relay to new pump for carbs,can anyone direct me to it?ive searched but cant find it

i meant upon removal of fi

http://www.914world.com/bbs2/index.php?showtopic=25954

the wires to your old pump would be used, in addition top the jump at the relay board.

There are photos to show this but until someone posts one I will try to verbally describe it. You will need a jumper from ground to one one the exposed terminals that the FI harness was plugged in to. I believe it is out board drivers side closest to the driver. Hope that makes sense

I will try to get a photo once I get home

David

thats the post i wanted,thanks

There is a cleaned up version of that post in the tech articles:
http://www.914world.com/specs/SirAndyCarbFuelPumpRelay.php