Kerrys914
Jan 5 2005, 12:58 PM
Shop 1, $540 plus parts
Shop 2, $500-700 plus parts
Shop 3, $700-$1200
Shop 4, $300 plus parts (Can't get intouch with him since my last e-mail 12/24/04?)
I need a basic valve job. Clean, inspect, 3-angle valve job, install new guides, reassemble and confirm setup.
The heads are off and ready to ship and/or drop off.
Lets hope the valves are OKAY..
J P Stein
Jan 5 2005, 01:13 PM
I sent mine to EBS.
All new intake valves...out of spec.
New springs......should be automatic with an unknown set.
Prompt service.
Total cost was around 800 bucks.
joea9146
Jan 5 2005, 01:25 PM
I used Anchor Atlantic in NJ to have my heads redone .....
Call Bob at Anchor Atlantic 856-589-5577
TimT
Jan 5 2005, 01:49 PM
Also Verdon Tool in Blackwell (?) NJ
German Presision in Ca does a good job at reasonable prices also
Wonder if these two places were on you list?
Eric_Shea
Jan 5 2005, 02:48 PM
Check EBS site for pricing.
P.S. Send mushrooms!
Root_Werks
Jan 5 2005, 03:05 PM
Looks like Jeff already sent you a PM. Go with him if you can. I have installed much of his work in customer cars. He is top notch, his workmanship rocks!