Mark, I'll take two. Everyone needs a spare. As always, Thanks!

please count me in for "all three pcs" too.

I will take a set.

I need a couple, all 3 pieces.

Mark -

I'll take two please!

I'll take two. Thanks!

By the way I will be making the band clamps for all that need them too.

I'll need one.

I need the cover and a new clamp would be awesome too

one for me.

thanks,
Jerry

Two for me please.

Vysoc

Thank you for making them!!

band and cover for me.....please and thanks

I'll definitely take one and the boot and band also

We already PM'd for two, but will take the trifecta as well ! Thanks

Hi Mark,
I could not remember if I had said so but I will take one of all three pieces.

Regards,

Grant

Just drop a +1 on the threw here. I drop PMs to all when it goes down.
Thx
Mark

I will need a band also. I have the boot.

Is this still open? I would like a bunch. Like 6.

Thanks!

Yes it is. We are about 20 days from finishing the tooling and will have the production to follow.

I would get 2-3....

Oh wow - just saw this. ONE for me, with the band, please

One for me please

I'll definitely take one and probably will need the boot and band also.

Jeff B

I will have the 1st article this next week after the dash tops are done.

+1 thanks

One for me too!

I need the boot and the band. Don't remember if I already said this. Getting old and the memory is shot.

Put me down for one and a band clamp. Thanks Mark.

+1 on all three pieces, pleeeeze :-)

I'll take a boot , a band and a cover.

Two for me plus 2 bands

+1 here. Thanks

I would like one set, boot, band, and cover (?). Please instant message when these are done and it's time to pay. Thanks for making these.

I'll take a set-up. Got a side-shifter conversion to do.

One with the band please. Thanks in advance!

Boot band cover

I'd like 2!

I would like all 3 pieces

I would like to have one please with a boot and band.

One set (boot, band, cover) for me, please.

I'm in for one and band .. Wes

The tooling is done, it did take several shots at the slide to make the input shaft form with the lip correctly.

We are going to be busy with the dash top for the next 3 weeks but after that these will start rolling out.

top

I would like to up my order to 2 to have spare.

I finally got a little quite time this evening to check the fit. The new bands are not ready yet but I'm quite happy with the fit and our choice of plastic. It's hard enough to protect it and flexible enough to bend it out of the way to tighten the set screw easily.

I was concerned that we had made it hard enough that it might not flex enough.

I would be on the production of these earlier, but I need to finish up the dashes before I can open up the GB. These will be worth the wait.

I got mine today

Bands are done and going to plating. These will be available next week. They are going to be plated gold zinc like OEM. They will run $12, after the GB $19. And will come with an instruction sheet as they are a little tricky.

Pms going out to all tonight.
Mark

Two complete sets of these as well. Thanks again

I believe I already threw my hat in the ring for a new cover a while back ... please count me in for one of the upgraded bands as well (can be shipped with my dash if there's room inside the shipping container)

LMK and I'll send you payment for the cover and band

put in for one earlier - just to clarify I'm in for the set boot band and cover!
can be shipped with carpet set if space available
let me know when and where to send payment
thanks!
cjl