Parts, parts and more parts…Risking life and limb from my wife, I (again) bought a roller to get some bits I needed including a side-shifter trans. It has been off the road for nearly 2 decades, but under cover. Hope its organs can help other teeners live on (shot drivers lateral and inner pass well. But might provide some other good sheet in the hole). Some really nice stuff. All prices include shipping and PP fees unless it states shipping not included. This is only on the big stuff. Glass will be packed in uhaul mirror boxes after being wrapped and braced w/cardboard. Shipping is from 85297 and my pricing is usually slightly better than FedEx website through my company. Let me know if there is anything you are looking for if its not listed. No engine. I have sent and recieved doors and bumpers through greyhound a number of times as well.
1.8 Engine tin, nice set cleaned and ready, little surface here and there. Most rubber and covers intact and nice. $150
Cooling Shroud and Fan Dirty but nice, Ill get it cleaned up and post a better pic, Alt not included and Alt tin goes with above set. $150
Wing window set Outstanding rubber, chrome and glass, very nice units. $100/Set
Rear Lights Lense (1) and Buckets. Buckets are decent, Pass lens is broken can include if wanted. $40
Dizzy Spins free unsure of condition though, visually nice unit $25
Dash Bottom Pad with Stainless trim. Includes vents Very presentable. Some small cracks from the bottom fastener holes back, should not be visible when mounted. $60 PLUS actual shipping.
Headlight Motors Will remove and test in my car $40 each or $125 for all light hardware buckets, small bumper to light trim and all Mounting hardware.
SOLD Pending****Targa Top Nice liner and shell rubber is rough. All latches. I had though about using it to hard mount a bike rack to, zero room in my garage for those shenanigans though $75 Plus shipping. Ill pack it in a uhaul art box.
Side Rockers. Look great. Will pull to check condition tonight. From what I can see looks to bee some surface but otherwise solid. $85 Pair
NEW Jack receiver plates. Unused, in primer still $20 Pair
Alt and 2 Starters (Bosch) Will have each tested in the AM $50 Each
Rear Glass Very Nice $75 Pus Shipping. uhaul art box
Door Glass $40 ea Plus Shipping
Clear Windshield and Chrome Molding The glass has a couple very slight pits, but no stars or cracks, VERY nice as is the Chrome molding. Bottom corner pieces could uses some gentle shaping with the eraser end of a pencil but very presentable still. $150 Plus Shipping will pack very well. Will separate.
Heater Controls $30
SOLD PENDING***Outer Door handles, Ignition switch, front trunk handle and rear hood buttom, Keys and one black OEM 914 key new in bag. $100
Tach and Speedo Unsure of functionality $50
Very nice Horn Pad 901 part number, very nice small chips in paint around corners of ring Pad is great. $60
Side door ding Moldings set. $35
Ash Tray Looks to be lightly used, Ill clean it up. Very nice though $15
Metal Front Valance Some dents around arm mounts, some surface rust. 4 of 10. $45 plus shipping
Rear Bumper Painted black, Top rubber strip is rough but intact. Bumperettes are slightly better. Includes struts. $60 plus shipping.
Door panels with arm rests and pocket. Very nice and presentable. Top of Pass door has some very small hairline splits on just the top roll. Nice functioning pocket lid on drivers door. Panels are black basket weave texture. $80 gets it all.
Side shifter couplers and tubes. Knob on shifter is an old Wooden one, shifter and tubes are nice. Will require the engine mount bar if going from a tail shift. Trans not for sale. $75
SOLD PENDING***Black Sun Visors Presentable, not split or faded $25 Pair
Hella front Turn Buckets (No lenses) Nice clean units, $25 Pair
Wiper Motor and Mech. Can included arms $50
Wash Bottle $20
Brake Reservoir $20
Gas Tank *Inquire. Nice tank and Cap can have boiled out local cheap
Tank Strap $20
Original Ski rack! Kind of a cool nostalgia piece. Stainless has original padlock...but no key. Little dirty but should clean up well. This fits the factory mount holes on the underside of the roll bar and slot in the header. $60 shipped
Click to view attachmentClick to view attachmentEverything should be priced very fair considering packaging, PP fees I will be covering and shipping on most items. But let me know if I’m out of line one anything. Also let me know if ther is something you need that is not listed. The car is very straight with some great metal. Discounts for local pick-up. Will start posting some pics tonight.
Thanks Folks!