The pins are almost impossible to get a grip on. markB says they can be pushed through per the Rekeying Thread but I don't feel them moving yet.
Right now I'm soaking the pin portion in PB Blaster.

Anyone figure out a better way to remove them ??

http://www.914world.com/bbs2/index.php?sho...c=66709&hl=

They only push thru if the key is out. Try a small pair of nippers or wire cutters to pull on them.

I have the key out; I don't have a small enough tool to grab the pin. There's minimal clearance around the pin and my smallest needle nose pliers won't let me grip the pins edge.......

I use a small drift pin punch and drive them both out from one side.

Is the drift punch round ? If so, I have a set....

Depends on the hole.
This one yes. Big enough to get solid impact on the pin, small enough to clear the chamber it's pressed in.

Got it: will give it a try.....

The drift did the trick- thanks

I assume the original roll pins can be reused ?

Absolutely