Hi folks!
Finally making some progress on my 2056 project.
I'm in the early setup stage and have some flow
dynamic questions for the public:
My ITB are ID 45mm, manifold 47/36 and my 2L
heads 36mm.
Do you guys believe that the 45 to 47mm step will
cause some issues?
Also, the intake's outer bolt area has too much "meat"
for the head studs - market red.
I was thinking of grinding down the extra material.
Last but not least, what's a good place to source 45/36mm
intakes?
Thanks for your feedback!
Click to view attachment
Click to view attachment