First I wanted to include this from SirAndy

Click to view attachment




This is from my 72 restoration project.
Here is the way I installed my wire harness. Step by step.

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Remove plastic guide tube
Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment
.
Click to view attachment

Must move this conector through the hole, the harness is to stiff to do this step later
Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Click to view attachment

Very nice car porn

Thank you

This is from my 72 restoration project.
Here is the way I installed my wire harness. Step by step.


Click to view attachment

Click to view attachment

these photos show a black tube inserted from the tunnel to back thru the firewall.
Is this a part of the harness, or a separate rubber or plastic tube just used to help feed wires thru ?? If so what size ?

Just a black plastic large cord holder, with the slip down the side . Its only to protect and guide the harness.


Click to view attachment

Garland;
Thanks for quick response, good stuff !!

Figured out today that you can cut off the end of the 914Rubber Snorkel tube to use as the wiring harness grommet in to the front trunk. Early uses on end, late uses the other end