This one is a little special to me. It's the last part Cary asked me to make.

Is your rubber piece too short?

Actually, this is a piece we didn't make but is being sold as a clutch stop. We had purchased them to resell. But they aren't right for the clutch stop.

Use two and sell it as: "too long, needs trimming"

Much better

We plan to do a GB for these at $3 for both pierces.

Just thought Id post this up as I promised Cary Id make these. So its not just the part, but my way of getting some closure. It bothered me seeing the sample sitting on my desk

The part is for the pedal assembly brake stop.

It is the brake and clutch pedal stop for the pedal set. It is a different profile abd does not fit the pedal board stop unkess you grind down the back side.

We’ve made an extrusion that an do both

@Mikey914
What will be the price for the brake pedal stop? The aftermarket ones are $2.50 from Pelican. I use a lot of them.

The GB will be $3 for both. As far as hooking you up with a bulk price I can save you money on that. Mark