A member was making these years ago. I never tried to install it...someone here might have tried one and can comment. IIRC you don't have to modify the lid to use this.
Click to view attachment
Full Version: FREE: 3D printed engine lid quick disconnect
I’ll take it.
Thanks
Al
Thanks
Al
PM Sent!
QUOTE(ahycaramba @ Feb 3 2022, 01:11 PM) 
I’ll take it.
Thanks
Al
Al - you are the winner. Check your PMs
Neat idea. I would be cautious though. If these were made with PLA the heat might not hold up to well in the engine compartment. Depends on how hot it gets in there. I made some directional vents for my 911 and found the heat started to warp them some I'm going to try PETG next.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.