Defrost rear window. One connector is missing, as pictured.
This can be repaired. See Brent's thread where he did this very thing.

I can't guarantee the defrost works, as I never had it installed. But there's no reason to believe it won't. It looks in good shape, other than that connector. I'm just trying to be transparent. ( )

I don't have the wiring harness, or switch, just what's pictured.

@bbrock Brent, any chance you could post your pic or add a link to your thread where you did the connector repair? Appreciated!

Take a volt ohm meter and test each line side to side. IF you see a solid short the grid is good.

Found it. The first repair I did (fabricating a new tab and soldering to the window silver) starts here.

Later the silver the tabs were attached to came off the glass so I repaired using conductive epoxy which starts here.

Chris,
I will take it. I will arrange for Rich to pick it up.

Check your PMs.
Bob