I'm getting ready to put gauges in Ruby.

Where are the Center Console Wiring Harness connections? I have the diagram.



Are these them?

https://www.pelicanparts.com/techarticles/9...e_pic21_big.JPG

Not enough wires and they don't match up.

TIA,

GN

Maybe these will help. From here: https://bowlsby.net/914/Classic/TechNotebook.htm

Jeff -

PERFECT! The sketches of the connectors explain it all!

The diagram at top implies 3 black connectors - 3 brown, etc. - not one. Repeat.

So simple - got it now! Piece of cake!

Thanks so much!

GN

Top drawing misleads because it even says that each yellow rectangle is each a 6mm female spade terminal.........I have over 50 years of believing electrical drawings to mean what they say!

But now I see only the 5 at the bottom refer to what is on the floor........my bad.....

I can easily make my own harness......

GN

Kind of on topic......What does this (black) harness connect to?

asking for a friend......

What harness? The black plastic connecor housing under the passenger seat?

Yes. It's not hooked to anything, and it was sitting on top of the center tunnel.
I don't remember seeing it before, and my early car doesn't have one.

Thanks

That's the seat belt interlock relay housing. It would have 2 relays attached to that housing.
Looks like it's been jumped already. See the larger yellow/red wire that's been spliced together. That's the fix. I would take a look at splice job. Most of the time they are just butt connected together. I would clean that up and solder those wires together. Rest just tape up and leave under the seat. I jumped out my brother's 74 but left everything in the factory location.

FYI to OP
http://www.914world.com/bbs2/index.php?showtopic=370013