Help! I can't find a source for the o-ring shown on the right side of the photo
(just to the left of the drive gear) for the speedometer drive out of my 901 tranny. I really don't want to buy an entire tranny gasket set just for this o-ring.
Measured the groove to be: 3.13mm wide X 25.6mm diameter.
so
I tried a 3 X 25.....TOO BIG....won't fit into bore.
then I tried 2.5 X 22.....TOO SMALL....doesn't make a good tight seal??
It must be a 2.5 X 24 ... but I can't source one?????