 Source for speedo drive o-ring??, Anybody got one? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| root |
 Feb 14 2006, 07:59 PM
Post
#1
|
|
Two Wheeled Type4 Completed!  Group: Members Posts: 849 Joined: 5-May 04 From: Sterling, VA Member No.: 2,026 Region Association: None  |
Help! I can't find a source for the o-ring shown on the right side of the photo
(just to the left of the drive gear) for the speedometer drive out of my 901 tranny. I really don't want to buy an entire tranny gasket set just for this o-ring. Measured the groove to be: 3.13mm wide X 25.6mm diameter. so I tried a 3 X 25.....TOO BIG....won't fit into bore. then I tried 2.5 X 22.....TOO SMALL....doesn't make a good tight seal?? It must be a 2.5 X 24 ... but I can't source one?????(IMG:http://www.914world.com/bbs2/html/emoticons/headbang.gif) Attached image(s) 
|
   |
 
|
Posts in this topic
root Source for speedo drive o-ring?? Feb 14 2006, 07:59 PM
Porsche Rescue PET says it is 25x2.4 Have you tried Porsche?
PN... Feb 14 2006, 09:09 PM Headrage The dealer sells them for a buck... Feb 14 2006, 09:09 PM root Nope, guess I should try Stoddard. I'll call t... Feb 14 2006, 09:12 PM messix lowes Feb 14 2006, 10:30 PM jimtab I used a buna-n seal from my plumbing box...fit li... Feb 14 2006, 10:51 PM TimT Can you wait till tomorrow? Ill go out and look in... Feb 14 2006, 10:57 PM gregrobbins I got one that works great in the plumbing departm... Feb 14 2006, 10:59 PM
root Alright, first I'll try Lowe's 'cause ... Feb 14 2006, 11:18 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 18th May 2024 - 11:52 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.