vesnyder
Nov 29 2007, 05:51 PM
Thanks to a fellow board member I got the dial indicator to set my crank end play. My issue is that teh spacers measure .010" and I have an end play measurement of .009"? Are there spacers that measure less. After pulling two motors all spacers I have are the same thickness. Any suggestions?
TheCabinetmaker
Nov 29 2007, 06:24 PM
Yes. some one here will have some for ya.
914Sixer
Nov 30 2007, 12:57 PM
Shims in 24,26,28,30,32,34,36 thickness. They are still available from Porsche or any place selling VW Bus parts.
Joe Ricard
Nov 30 2007, 07:21 PM
Just pulling this off the top of my head (maybe the other end however)
.002 to .005 is the end play #
With all the shims out you should have LOTS more than .009 even on a new motor.
My new motor required like .034 worth of shims it took 3 shims to make up the stack.
Are you measuring right?
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please
click here.