machina
May 14 2008, 03:43 AM
one of my output flanges has a stripped thread in one of the four bolt holes.
want to take good flange off spare tranny and install on tranny in car.
are there special procedures for doing this? what is the torque for the big center bolt?
thanks,
dr
Gary
May 14 2008, 06:34 AM
Nothing special - take the center bolt out. Pull off old flange, put on new flange. Reinstall bolt. Lotta torque values here:
bird board.. Says 25-29 ft/lbs.
DNHunt
May 14 2008, 07:55 AM
Take a good look at the seal. My experience (1 time only) was new output shaft with old seal = leak. If it looks worn or hard I'd replace them both.
Dave