messix
Apr 11 2009, 04:37 PM
jimkelly
Apr 11 2009, 05:26 PM
http://www.youtube.com/watch?v=nCRZ-BMejZsthat idle is driving me crazy - would someone pls push down on the gas peddle : )
Sleepin
Apr 11 2009, 07:10 PM
With a hat like this, you could easily a AEM style ricer tube!
It would make for some nice, low profile systems.
Phoenix-MN
Apr 11 2009, 07:21 PM
"It would make for some nice, low profile systems."
Yup, it fits under the stock lids with no clearance problems at all
Click to view attachmentPaul
Sleepin
Apr 11 2009, 07:27 PM
QUOTE(Phoenix-MN @ Apr 11 2009, 07:21 PM)
"It would make for some nice, low profile systems."
Yup, it fits under the stock lids with no clearance problems at all
Click to view attachmentPaul
Paul, were you able to use that firewall piece I sent you? :highjack:
Phoenix-MN
Apr 11 2009, 07:36 PM
"Paul, were you able to use that firewall piece I sent you? :highjack:"
Eric,
It's just getting warm enough here in MN to go back into the garage so I haven't done any work yet. But yes, the panel is fine and will work for making the access hole through the firewall.
Thanks
Paul
'73-914kid
Apr 11 2009, 08:15 PM
Old 70's LT1 Corvette's had a hish rise intake manifold. They then had to use a drop base air cleaner. This gets the air cleaner top litterally at the topline of the carb. quite impressive really..
I'd expect it to work for a 914, just as it works for my dad's Vette.
TC 914-8
Apr 11 2009, 11:26 PM
QUOTE(Sleepin @ Apr 11 2009, 06:10 PM)
With a hat like this, you could easily a AEM style ricer tube!
It would make for some nice, low profile systems.
I had a plentum like that on my first V-6 914.of course it was mated to a Paxton blower. I later modified it thru an intercooler with a different setup. here is a pict of my first set up. I coud see running this plentum to an air box then to a side scoop.
Click to view attachment