Hey, i want to apologize if this has been covered, but i cant seem to find it..
Im in the process of rebuilding the top end of my engine. (the valve seats fell out of my last one) so assuming that it was still a stock 1.7 i got some new heads for it.
Now i have found that someone put 94mm p/c in it..
Im assuming they didnt put a bigger crank in it and it is a 94x66 = 1832. what should i do for injectors? i've read that putting in ljet 1.8 injectors dont work.

You can use the same injectors, but you'll need to retune slightly by one or more of the following:

1. Raise fuel pressure.
2. Retune MPS.
3. Add TS2 resistance.

Or, unplug the intake air temp sensor.

Is it L-jet or D-jet?

Just curious?