 CV Bolts & Bolt tool?, more shitty one-off porsche tools? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jandro62 |
 Jul 7 2004, 04:01 PM
Post
#1
|
|
Member  Group: Members Posts: 104 Joined: 4-June 04 From: Texas Member No.: 2,156  |
Ok, so when I went to drop the transmission, the cv bolts looked pretty chewed. Where can I get a fresh set of these? What size are they? Also, I've seen references to a special tool for removing them? Are they just a little different than a torx bit? Pelican Parts lists bolts & tool for a 68+ 911, is this what I want?
|
   |
 
|
  |
Replies
| Malmz |
Jul 7 2004, 07:19 PM
Post
#2
|
|
CSOBOSC founding member Group: Benefactors Posts: 489 Joined: 22-April 03 From: So. Cal Member No.: 602  |
My Sears no longer has them (I checked recently).
Pep Boys did: All the info you need should be in this picture. Less them $10 for the set if I remember correctly: From my experience, always tap them lightly with a hammer to fully seat them though the muck and grit before torqing on them. Attached image(s) 
|
|
|
|
Posts in this topic
jandro62 CV Bolts & Bolt tool? Jul 7 2004, 04:01 PM
TimT its a double square bit, 8 points. Torx are 6 i b... Jul 7 2004, 04:55 PM Joe Ricard Got to have a good "tool" to work on 914's
I ... Jul 7 2004, 04:57 PM davep I thought it was a tri-square, but I could be wron... Jul 7 2004, 05:20 PM SLITS How bout a 12 point Star bit or just ask for the V... Jul 7 2004, 05:28 PM TimT I was just thinking it might be a tri-square also.... Jul 7 2004, 05:29 PM TimT tri square is correctamundo Dave...
here are some... Jul 7 2004, 06:02 PM TimT Snoooozle Jul 7 2004, 06:03 PM Kerrys914 $10 and PParts sells one for $20 somthin... Jul 7 2004, 07:28 PM Malmz No affiliation or experience:
http://www.thetoolwa... Jul 7 2004, 07:38 PM MarkV It's nice to have one that goes on a 3/8" ratc... Jul 7 2004, 07:51 PM TimT It wouldnt surprise me a bit if Pelican takes "lib... Jul 7 2004, 07:52 PM
Kerrys914 :headbang: :headbang: :headbang: :headbang:
3... Jul 8 2004, 06:09 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 4th July 2025 - 11:16 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.