 e-brake handle assembley removal, how do you do it without affecting current set up?t |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| drem914 |
 Feb 25 2019, 10:32 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,032 Joined: 16-May 08 From: Trabuco Canyon, CA Member No.: 9,062 Region Association: Southern California 
 |
I am in the process of installing the vinyl and carpet kits from 914Rubber, but need to remove the e-brake to remove the old carpet and install the new one. What is the process without affecting the other connections back at the rear of the car? Is there any special tricks to removing the handle assembly and not play around with the settings at the back brake?
TIA |
   |
 
|
  |
Replies
| bbrock |
Feb 25 2019, 01:04 PM
Post
#2
|
|
914 Guru Group: Members Posts: 5,269 Joined: 17-February 17 From: Montana Member No.: 20,845 Region Association: Rocky Mountains
|
Disconnect it at the pin just in front of your red circle. The clip in your pic slides off the end of the pin and then you push the pin out of of cable end.
|
|
|
|
| drem914 |
Feb 25 2019, 01:27 PM
Post
#3
|
|
Senior Member Group: Members Posts: 1,032 Joined: 16-May 08 From: Trabuco Canyon, CA Member No.: 9,062 Region Association: Southern California
|
QUOTE(bbrock @ Feb 25 2019, 11:04 AM)  Disconnect it at the pin just in front of your red circle. The clip in your pic slides off the end of the pin and then you push the pin out of of cable end. Thanks, I was hoping that might be the case, but wanted to make sure. Going to add some penetrating fluid first to help remove both the handle and pins. |
|
|
|
Posts in this topic
drem914 e-brake handle assembley removal Feb 25 2019, 10:32 AM
drem914
I am in the process of installing the vinyl and c... Feb 25 2019, 10:44 AM cuddy_k You don't need to disconnect the cable. Just u... Feb 25 2019, 11:49 AM
drem914
You don't need to disconnect the cable. Just ... Feb 25 2019, 12:10 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 07:23 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.