Transmission cooler Help..., Not sure where to Tap |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Transmission cooler Help..., Not sure where to Tap |
joea9146 |
May 9 2005, 06:24 PM
Post
#1
|
Senior Member Group: Members Posts: 663 Joined: 10-February 03 From: Denver, NC Member No.: 283 Region Association: None |
I am installing a Tranny cooler... I got the fittings to fit the drain and fill plug .
Everything was going fine until I got under the car. The Throttle linkage for the 6 blocks the drain plug. So I was going to tap the case next to the plug and insert the fitting there. My only apprehension is the case in that area has a slight bevel where I want to tap it... Any ideas or other suggestions. Attached image(s) |
slivel |
May 10 2005, 12:54 PM
Post
#2
|
Old car....... older driver Group: Members Posts: 510 Joined: 10-July 04 From: San Diego Member No.: 2,332 Region Association: Southern California |
It is the stock plug with a 3/8 inch hole drilled in it. Then weld on a steel elbow with the AN size of your choice. I used AN 6 if I recall correctly. The steel elbows are available form Pegasus racing, Earls and other places I'm sure. The one that I used was a steel AN6 and pipe thread adapter elbow. I cut off the pipe threads and butt welded it to the drilled stock plug. It's not hard to do and not expensive.
|
Lo-Fi Version | Time is now: 29th May 2024 - 03:26 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |