 What is the best way to remove, Rubberized undercoating? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| skline |
 Mar 23 2007, 01:20 PM
Post
#1
|
|
Born to Drive  Group: Members Posts: 7,910 Joined: 26-December 02 From: Costa Mesa, CA Member No.: 17 Region Association: Southern California  |
Ok, I decided to strip all the undercoating off from the areas I want to weld in the stiffening kits. I thought it was just some thick black paint but it is in fact undercoating. I got a chemical stripper and it says it will remove all coatings in one shot. I have applied the first coat and then scraped it but it seems a bit tougher than I thought. Any other suggestions on what I can use to remove all this stuff?
|
   |
 
|
  |
Replies
| i love porsche |
Mar 23 2007, 01:36 PM
Post
#2
|
|
Senior Member Group: Members Posts: 1,547 Joined: 6-May 04 From: Nutley, NJ Member No.: 2,030 Region Association: North East States |
wire/cable wheel is probably the easiest..but also going to be slow
ive found that a heat gun and a paint scraper works well, also an acetylene torch, just have to be careful with it i dont think sandblasting will work, since the coating is relatively soft, it will jsut absorb the material and the impact |
|
|
|
Posts in this topic
skline What is the best way to remove Mar 23 2007, 01:20 PM
Aaron Cox midgets with scrapers
slave labor
day workers
sand... Mar 23 2007, 01:24 PM sj914 Wire wheel on an angle grinder. use the twisted k... Mar 23 2007, 01:33 PM
Johny Blackstain
wire/cable wheel is probably the easiest..but als... Mar 23 2007, 02:06 PM jd74914 For a lot of the undercoating on mine I used a tor... Mar 23 2007, 01:39 PM skline Thanks guys, I will try it. Lot's to do to str... Mar 23 2007, 02:09 PM bd1308 gasoline does real well
cab cleaner works well to... Mar 23 2007, 02:54 PM Porcharu Angle grinder with a wire/cable cup wheel. Goes t... Mar 23 2007, 04:06 PM skline
Angle grinder with a wire/cable cup wheel. Goes ... Mar 23 2007, 04:11 PM Johny Blackstain
Angle grinder with a wire/cable cup wheel. Goes ... Mar 23 2007, 04:36 PM Twystd1 Scott,
If it's aftermarket undercoating. You ... Mar 23 2007, 04:19 PM Bartlett 914 I have been doing a lot of this lately. I use a ma... Mar 23 2007, 05:19 PM George H. So is the consensus bare metal under factory under... Mar 23 2007, 05:29 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 31st July 2025 - 11:35 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.