 Need Quick Help / Advice, Carb Questions & Rust Repair |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Pnambic |
 Aug 22 2004, 10:10 PM
Post
#1
|
|
Honk if you like obscene gestures!  Group: Members Posts: 914 Joined: 9-April 03 From: Atlanta, GA Member No.: 546 Region Association: South East States  |
OK, 2 Questions:
1.) Anyone have a really good book I could borrow or a suggestion on one to buy that might help me get a pair of webers back together and ready to go in time for the FFC? 2.) What gauge and type of metal should I use to patch the passenger long at the jack point? I think I'll just cut out whats left of the jack point and close it up, for now. MANY MANY MANY THANKS IN ADVANCE!!! Attached image(s) 
|
   |
 
|
Posts in this topic
Pnambic Need Quick Help / Advice Aug 22 2004, 10:10 PM
Joe Sharp Old AAA, and cut that rust off. I haven't used a j... Aug 22 2004, 10:33 PM bperry Can't offer any advice for the rust but for we... Aug 22 2004, 11:22 PM Jeroen 1mm sheetmetal
sorry, dunno what gauge that is in ... Aug 23 2004, 05:18 AM balljoint 1mm sheetmetal is 20 Gauge (0.036")
Is that thic... Aug 23 2004, 01:56 PM TimT 20ga is plenty thick, you can use 22ga even as its... Aug 23 2004, 02:28 PM balljoint What gauge are those longs made out of to start wi... Aug 23 2004, 02:33 PM Jeroen the longs are made of 1.0 of 0.8mm Aug 23 2004, 05:25 PM Pnambic Cool. Sorry for the lack of response. I was out ... Aug 25 2004, 09:39 AM indydad I'm using 18 ga for this area. 20 for the othe... Aug 25 2004, 10:54 AM
SpecialK   |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 5th June 2024 - 04:09 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.