 another welding question, how bad is it... stainless to steel |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| brant |
 Apr 25 2005, 03:47 PM
Post
#1
|
|
914 Wizard  Group: Members Posts: 11,641 Joined: 30-December 02 From: Colorado Member No.: 47 Region Association: Rocky Mountains 
 |
Ok...
how bad did I screw up the metals? what is the correct way (type of wire, type of shielding gas) to weld Stainless steel and regular steel? to top it off this was a piece of galvanized pipe no less: Attached thumbnail(s) 
|
   |
 
|
Posts in this topic
brant another welding question Apr 25 2005, 03:47 PM
TimT I wouldnt worry about it... it might not be the pr... Apr 25 2005, 04:01 PM lapuwali That looks like an exhaust fitting, and if so, I... Apr 25 2005, 04:50 PM scotty b It will werk just fine but for future reference CL... Apr 25 2005, 05:44 PM John Kelly That weld turned out nice (could have been a wee b... Apr 26 2005, 06:56 AM brant Thanks guys..
I knew it wasn't going to be the... Apr 26 2005, 10:08 AM
Brett W When welding stainless you need to run a purge gas... Apr 26 2005, 10:41 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 12th June 2024 - 12:21 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.