 Sun visor, keeps falling down |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| theer |
 Aug 10 2018, 08:32 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 692 Joined: 31-July 15 From: Dover, MA Member No.: 19,014 Region Association: North East States 
 |
My driver's side sun visor has a habit of working itself loose from the outside (left) mount.
I've remounted it several times, making sure the pin in set all the way into the mounts on both sides (and the square post properly oriented). But, if I tighten the screw holding the pin in tight enough to prevent the visor from drooping, moving the visor up and down sloooowly works the pin out of its mooring. Anyone else had this problem and has found a fix? Thanks, Tom |
   |
 
|
Posts in this topic
theer Sun visor Aug 10 2018, 08:32 AM
mgphoto Just tighten the screws enough to move the visors ... Aug 10 2018, 08:49 AM theer yup - that's what I've been doing. It tak... Aug 10 2018, 09:00 AM mgphoto If that is the case, you need to replace the visor... Aug 10 2018, 10:46 AM
drem914
If that is the case, you need to replace the viso... Aug 10 2018, 10:52 AM Bartlett 914 I had the same problem. I made new pins with a sho... Aug 10 2018, 11:55 AM Chris914n6 Is the pin coming out of the mount or the visor? P... Aug 10 2018, 01:31 PM Rob-O
Is the pin coming out of the mount or the visor? ... Aug 10 2018, 02:04 PM theer I do have the early chrome pins.
Rob - that is ex... Aug 10 2018, 03:48 PM Robnxious
I do have the early chrome pins.
Rob - that is e... Aug 10 2018, 04:35 PM Chris914n6
I do have the early chrome pins.
Rob - that is e... Aug 11 2018, 02:32 PM DaveO90s4 I have this same problem. Am thinking of gluing a ... Aug 10 2018, 04:43 PM bandjoey Miley 914 rubber might sell the new clips. Check ... Aug 11 2018, 02:12 PM BENBRO02 I used epoxy to attach the metal pins to the mount... Aug 11 2018, 02:33 PM mgphoto I would check for lubricant in the visor, use a q-... Aug 11 2018, 03:52 PM Perry Kiehl 1/8" roll pin/spring pin. Drill through the ... Aug 12 2018, 01:28 PM ClayPerrine I have super glued the pins in. We replaced the c... Aug 12 2018, 04:00 PM DaveO90s4 See my post 11 above. All works well - tube is a v... Aug 21 2018, 12:02 AM theer Thanks for all the responses. I haven't tried... Aug 21 2018, 08:01 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st August 2025 - 03:34 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.