 lowered spindles, shady grady & Jason style |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| sean_v8_914 |
 Sep 17 2005, 10:12 PM
Post
#1
|
|
Chingon 601  Group: Members Posts: 4,011 Joined: 1-February 05 From: San Diego Member No.: 3,541  |
this solves 2 of my problems
1 I want to use my konis 2 I want to lower my ride height the right way Jason at Prestige Motors just showed me this(and the entire PCA-SDR) 2 nights ago as a way to drop the ride height without adversly changing the suspension geometry. I posted a FS/trade ad here to try to trade my Konis for Bilsteins and shadygrady has shown me this as a solution to use my Konis with teh 930 spindles I am so glad 914clubers were here to club me over the head with the obvious solution to both problems. I hope this will benefit others. this is the easiest and most mechanically correct method ???how do I grind out the weld without a mill? how Attached thumbnail(s) 
|
   |
 
|
Posts in this topic
sean_v8_914 lowered spindles Sep 17 2005, 10:12 PM
sean_v8_914 xcgfdx Sep 17 2005, 10:12 PM sean_v8_914 xcgghc, Sep 17 2005, 10:13 PM sean_v8_914 uho8y Sep 17 2005, 10:13 PM Aaron Cox one can only go so far before the wheel hits the a... Sep 17 2005, 10:15 PM sean_v8_914 I will drop mine one inch only Sep 17 2005, 10:17 PM sean_v8_914 THANKS GRADY! http://www.... Sep 17 2005, 10:18 PM rdauenhauer So Sean, more details. Are those 911 or 914 strut ... Sep 17 2005, 11:00 PM brer put the whole strut assembly on a lathe and cut th... Sep 17 2005, 11:24 PM sean_v8_914 shadygrady did the ones in teh picture
the tubes a... Sep 18 2005, 01:59 AM TimT if you dont have a mill, use a hole saw. We drillo... Sep 18 2005, 06:05 AM sean_v8_914 what do you gusset? what is teh weak part that req... Sep 18 2005, 09:40 AM Verruckt Nobody has mentioned this yet, but a fellow club m... Sep 18 2005, 12:34 PM ArtechnikA if it's a factor, be sure to check your compet... Sep 22 2005, 05:57 AM sean_v8_914 I will be doing this on my V8 car, not the 2.0 CS ... Sep 22 2005, 10:35 AM J P Stein Note the joggled pitman arm in the pics of Chris... Sep 22 2005, 10:46 AM
Brett W You can't take the stock 914-4 spindles and cu... Sep 22 2005, 11:49 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th June 2024 - 07:47 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.