Parting out another 1972 914. Body panels are rough but many good parts available. Let me know what you need. Bill (704)829-0976 email billywhitesides1@aol.com

Click to view attachment

Any good condition centercaps for those wheels??

Would you happen to have an original interior light? Thanks

How's the front floor? Was it cut for AC condensor?

shoot me a p.m. on the lug nuts

mike

Front swaybar available?

PM sent

Ed. No center caps
Jonathan. No good interior light
DB. I think the front floor is good. I'll check tomorrow
mike. I'll have to take a closer look at the lugnuts/lugbolts
Foster. No sway bar

Thanks BILL

How are the heat exchangers? Enginesize?
thanks

Click to view attachment


Do you have a passenger side seat to match the one above? Also, do you have detailed pics of your best tail lenses?
Jake

Porsche Rocker Panels

Click to view attachment

Do have the black piece that goes around the ignition key and part of the steering column? It covers the silver parts in this picture. I have a 76 but hopefully it was the same on your car.

If it's not the same, I have it. I just pulled it to install a complete earlier style setup.

do you have the plastic thing inside the door handle that usually breaks? need both sides

and driver interior door handle

front blinker lenses (tall skinny ones)

You can buy them new for about $15 from Pelican. It is called the door lstch cam.

http://www.pelicanparts.com/catalog/shopca..._pg6.htm#item31

but.. but... $15 (x2) for 2 little pieces of plastic.... im cheap... if someone will part it out cheaper im all for it

I need the passenger side exterior door latch if it's unbroken.

If you have a good complete rear trunk latch, windshield wiper mechanisms with no slop, taillight buckets if in good shape.
Let me know if and how much.

Thanks,

drivers side taillight?

You ready to get out the sawzall yet?

How's the firewall (metal between backpad and engine) look?

JustME: The engine is a 1.7. Sorry no good heat exchangers

Jake: Sorry my interior is the later 72-74 basketweave style.

Wiz Porsche: Yes the car has the raised letter PORSCHE stlye rocker panels.

State of Idleness: Yes I have 2 good plastic door cams, a good interior door handle and both front lenses.

RJM11: Yes I have this Piece.
pjf: I would appreciate it if you let me respond to the ad first.

Lotus 65: Yes the outer door handle is nice

Geniusanthony: Yes I have all the parts.

Mattp. I'll check on the condition of the driver's side tailight lens.

How about the shifter knob??

Thanks,
Tim

pm's sent to all above. Thanks BILL

...except me.

I asked about the firewall.
Are you not cutting it up?

What about the passenger side heater flapper? I need one.

I need a crank and the rods if it is a 2.L

Boa

Wanted: Driver side front fender and lights. I'm new to the 914 world and took a hit from a driver who ran a red light and took off this morning...any help is very much appreciated. thanks.

do you have a fresh air blower?
cf30@sbcglobal.net
94563

Click to view attachmentClick to view attachmentMatt: Yes on the driver's tailight

SlackeR32. I will have to pull out the seats and back pad and I'll get back to you on the rear firewall.

Tim. The 914 has an aftermarket Porsche Center crest shift know. I have a picture of it below.

Dennis. Yes on the flapper box

Boa: Sorry no 2.0 crank . I may have the rods.

Yellow 914: Yes I have the driver's side front fender from another 914. I also have both light assemblies

Chris. Yes I have the Fres air fan

Here is a picture of the shift knob. Will here is the picture of the passenger side tailight housing. Thanks everyone. Bill (704)829-0976 email billywhitesides1@aol.com

Hey Guys. The pictures uploaded side by side instead of vertically. PM'S sent to all. Thanks Bill

I need the clutch bracket assembly that bolts to the side of the tranny, including the plastic pulley. I may also need a tranny. Thanks!

I have all three. PM sent. Thanks BILL

The shift knob in the above picture is available for sale. Tim was looking for the factory style. Bill

Drivers seat pad?

Thanks

Wobbletop: What color and what year. There were several different patterns. Let me know. Bill

Black. It's the vinyl weave pattern. 1970

Yes I should have it. Let me check and I'll send a pm. Bill

Click to view attachmentClick to view attachmentPeter. Here are the pictures of the steering and both early style chrome inner door handle surrounds. The pictures may unload side by side rather than vertically. Let me know. Thanks Bill (704)829-0976 email billywhitesides1@aol.com

Click to view attachmentWobbletop. Here is a picture of the basketweave seat bottoms. I'll send a pm. Thanks Bill

How about a "crack free" rear targa roll bar pad?
Thanks,
Tom

uncracked rain tray?
Joe

Whats the outside mirrors like and how much do you want for them?

Do you have the wiper switch and do you know if it works?

do you have uncracked plastic headlight surrounds, both left and right? If so what color?

thanks,

Tom. Sorry no can do on the crack free pad

Joe. I may have the raintray. Do you need the early 70-72 year style or the later 73-76 one?

Chris. The outer mirror is there but not nice at all.

Shephen. Let me check on the wiper switch and I'll get back to you

Jorge. I have both black and white pairs. What color do you need?

Thanks Everyone. Bill (704)829-0976 email billywhitesides1@aol.com

Jorge. The white headlight surrounds are being shipped today.

Stehhen. Sorry the wiper switch has been sold.

Thanks Everyone. Bill (704)829-0976 email billywhitesides1@aol.com

How much for the rims

Do you want the lug bolts/nuts as well? These are specifically made for this rim? Let me know. Thanks BILL

Bill,
do you have the larger of the two ECU brackets, no rust/pitting?
Kev

Kevin. Let me check, I may have this. Bill

Do you have these?

Left side marker light
Side view mirror
Rear trunk upper latch
Rear trunk clips for the top